Question:
Recently my brake lights went out. So I changed the brake light fuse and they started back working. HOWEVER, now I dont have any turn signals. When I press the brakes, both of the turn lights come on until I release the brakes. Does anyone have some good sound advice. By the way, Ive looked at the other fuses. Even removed them and replaced them.
Answers:
I have a Ford A/C R134 with 0 pressure and won't accept a charge even if compressor is running.?
Check for a burned out bulb. If they both work in the back, check the front.I just replaced a bad starter in My 1988 Jeep, but now it just wont turn over. Loose connection?
ur cars broken get it to the shop immediatelyyou must have messed something up when you changed the fuse the first time, by accident of course.
take it for an inspection. they should be able to tell you what is wrong and how it can be fixed.
You need to check the wiring at your tail lights, it sounds like a wire or two have melted together causing a short, which originally blew the fuse and now has caused the wires to solder themselves together.
To rakel i found it thank you very much?
there sure is something wrong with your fuses. i recomment a real expert to check it, it has happend to me sometime but no matter ,What is the best GPS for car honda odyssey?
did you change the flasher.it might be going bad.What does the expression means by 3 bolt main?
did you force the bulb in with the two notches backwards?ive seen peaple do that.Why does my 1972 pontiac Le mans stall out when I stop the car?
Your brake lights and turn signals are the same bulbs and use the same fuse. Your flasher relay could have gone bad and blown the fuse. If it's shorted out inside it could be hooking the brake light voltage to the turn signal indicators. Replace the flasher relay. It could be the emergency flasher relay or the turn signal relay.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.