Mitsubishi suv,70k km,model 2000,gas,automatic,stalls... Idle speed control repairable or needs to be replaced?

Question:
my car stalls as i approach to a stop and when i step on the gas from a stop. starting it again though gives me no problem. idling is fine at 700 rpm,but only after cleaning the throttle body to get rid of the accomulated carbons around the throttle plate (butterfly) .somebody told me i need to replace my idle speed controller. shall i replace it at once or can it be just overhauled or cleaned? does fuel injector has anything to do with this stalling in a way?

Answers:

99 4Runner that runs rough & stalls after running 4 about 4 min. either hot or cold. not fuel filter,plugs,pcv

A 2000 model year car will not have a carburetor. EFI systems all have throttle plates and throttle bodies.

I took my 01 mustang to the shop and this is what they said about K&N fliters?


Second, unless I'm mistaken, cars around that year don't have anything called a "idle speed controller" in them. The closest thing to this is called the IAC (Idle air control) step motor, and while this cuold be the problem there are too many possibilities for you to just replace it out of nowhere. The best thing to do is take it to a drivability shop and have them do a scan on it to see what all the sensors are doing.

How often are you suppose to change tranmission fluid in a car?


Alternatively, you can replace the IAC or attempt to clean it. There is a very low chance that you will hit the problem spot-on but if you want to gamble the money then its yours to gamble.

Does this sound right to you?

First of all, your description tells me that you have a carburetor. If that is the case, your engine does not have fuel injectors.
Carbon buildup on the venturi (butterfly) suggest you got problems with the filters. Are you using aftermarket foam filters? If so, be sure to keep the foam filter cleaned and oiled regularly.

2004 Mitsu Lancer ES --How to Install Rotors?


Buy a can of spray carb cleaner, with the engine running at fast idle, spray into the venturi chamber. This should remove the carbon deposits and hopefully other gunk thats surrounding the jets.

Canadian Tire Auto department ripping me off?


If the problem persists, load up on premium high grade fuel and once the engine has properly warmed up drive around in low gear at high speed maintaining 3000+ rpms for at least 30seconds. If you are on a budget, just buy fuel additives and put the entire contents into your tank.

How often should you change the oil in your car?


There should be at least some improvement. If problem still persists, then you probably have a problem with the carb and will need servicing.
More Questions & Answers ...

  • Car electrical problems?
  • A prankster broke an egg on the hood of my brand new Honda Civic. How to remove?
  • Pontiac sunbird(1993)my car is bogging after the engine has warmed up.?
  • What is the difference between w5-30 oil and w10-30 oil? And can they be mixed?
  • I have a Valhalla Astra van 1.7 diesel with a burst timing belt.?
  • Why should I change my transmission fluid?
  • Why does my yammah 650 wave runner have water in the piston spitin out when i turn over the engine?
  • Idle Air Control Motor on a 1998 Grand Prix GTP?
  • Somebody hit my car and left on note with his#- the damage is on side and front bumper- should I move the car?
  • Gas guage not working correctly?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.