Jeep Wrangler engine rebuild?

Question:
I am about to pull the 4.0 v6 engine out of my YJ for a complete rebuild. I am hoping to get more power out of it. I was thinking about putting dome/high compression pistons and a performance cam...Is this a bad idea for this motor? Any suggestions?

Answers:

Why do gas pumps slow down when nearing the total (whe you pre-pay)?

thats a good start.what about a double roller timing chain,a 3/4 cam,have it bored and stroked,a high rised intake,roller rockers.if its a manuel tranny,what about a competition clutch.if its a automatic,put a shift kit in it.good luck with your project.

---

1995 Ford Thunderbird Overdrive Light Flashing?

The problem with beefing up the engine is it puts extra stresses on the rest of the running gear. Go ahead & give it some more jam, but expect more repairs.

Speedometer repair In San Jose,ca?

- - -

---

More Questions & Answers ...

Driving in high gear saves you money or screws up your transmission?

Buy extended warranty for 2000 Avalon?

Is this possible for a honda?

How does it cost to get a little rust under the car removed? Car is a 95 caprice classic?

Trying to look up this part for Honda Civic?

Where can i find a transmission for a 1991 2.0 lt beretta?

What is the best mag wheel offset to use in a 1977 corolla?

Are there any websites you can look to find out a part your looking for on a 1996 ford diesel engine itasensor

Key Stuck and Shifter Wont Go down to 4, 3, or 2...HELP!?

When I shift my car Into drive, It jerks really hard some times, why Is this?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.