Question:
Answers:
Where do I find car key code for 95 ford T-bird trunk?
The only way to repair this problem is to remove the headliner completly (for best results) and apply new adhesive that can be found at your local auto parts storehelp with ignition lock replacement??
Tons of duct tape and plenty of staples.I scratched my polished aluminum wheels - how can I fix it?
if you want to DIY, then go to the auto parts store and tell them that you want the spray adhesive that is made for that. You will have to put a small hole in the lining, but usually after adhering it back to the roof. it seals itselfyou,ll have to put a new headliner in it,,they fall down after about ten years or so,,my wife owns an upholstery shop,,and she does these all the time,,you have to remove the board that's up there ,clean it real good,and glue a new piece if material on it,,it usually cost around a 100 bucks to get a new one installed,,good luck hope this help,s.
get some thumb tacs and put up some photos
Do I have a blown head gasket?
The whole process takes 3 Hours if you have the right materials and is well worth it. Shops charge big Money for this and if you learn it you could open your own shop. Now it depends on what kind of vehicle you have, but all interior roofs can be replaced. It's better to have an assitant to help you, friend, cusin etc... Well first take the trim screws that hold your roof together (takes about 30 minutes) and remove the interior roof. You might have to remove the sun shades and intorior lights if applicable. Set it out side and measure it, write it down and take the measurements to the Nearest fabric shop and have them cut you out a peace that you would like for your interior. Next clean off all the stuff that was attached to your old interior roofs cardboard lining, make sure it's smooth and even all across it. Then lay your New material on top of it so you know that it is the right size. Then remove the laid on peace(the New Fabric) and spray the Cardboard liner with adhesive spray, let adhesive dry Ten minutes, (available at the Auto parts) lay the new fabric on top. Smooth it out so it matches corner to corner like when you test fitted it. Take an Iron set it to permenate press and start in the middle of your of your new fabric and Iron it flat working your way out of the middle. The heat will reactivate the glue and seal it to the cardboard. Let it lay flat for about an hour, flip it over and cut the fabric for you interior lamp then install reversed the way you took it out. When it's done it looks great. Good LuckMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.