What size drill for M12 tap thread cutting?

Question:


Answers:

1991 Caprice 5.0 eng. ECT?

10.5 and if you are tapping out steel use a cutting compound or oil ,if you are tapping out cast iron or alloy you don,t need a lubricant ,but use a tapper tap first .

---

question about my car.?

Look on the side of the tap, it will state what size drill to use.

---

Yall, I need a truck and the only thing I've got to put down is my beat up buick. I s there anywhere to get 1

10.2 mm coarse pitch and 11.0mm fine pitch thread.

---

I just bought a 97 Ford Escort LX. My fuel hand is stuck. I was wondering if it could be the sending unit.?

Hi there, there tap normally has printed on it's side the required drill size that has to be used. If the tap has a pitch of 1.5mm then take 1.5mm from 12mm and thats usually a good guide line!
Good Luck

---

What's the best way to remove rust from my tools that were out in the rain using household items?

to answer this question the thread pitch must be stated for 12 mm there are 1, 1.25 1.5 & 1.75 as popular pitches the finer the pitch the larger the tapping size 10.2 for the 1.75 getting it wrong means looking for someone with a t/sert kit that size to recover it

---

truck won't start its -12 here?

go for 10.5MM,it should give an average sixty percent thread form which is more than enough for anything other than specialised applications.remember to reverse your tap every turn or so to break the cut,WD40 great lubricant,even on cast iron,wear safety glasses!

---

More Questions & Answers ...

What is the best way to stop water from leaking into your car interior?

What would happen if you open the radiator cap while the engine is hot?

What is a good brand of snow tires?

2004 Grand Prix Won't Start Sometimes?

'93 nissan sunny 1.5L - suspect timing chain may have skipped a tooth. How can I confirm this?

Do I need to replace my PCM on my 96 Grand Cherokee Laredo V8 because of an open ciruit on injector 8?

A car problem diagnosis?

Is $320 a lot to fix a gasket valve cover?

Url that shows detailed diagrams and descriptions of what each part is and what it does in a chevy small block

how can i tell what kind of transmission i have?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.