Trans am with 350 csb?

Question:
do u have to set the valuve lash on rolling rocker on a 350 csb. If so how do u do it

Answers:

Replacing Throttle Postion Sensor? VW Jetta?

It depends on the camshaft. If it is a hydraulic, or hydraulic roller there is no lash. The valve is adjusted by rotating the camshaft to the fully closed position (bottom center of the cam lobe) on each individual valve, back the lash nut off until you can rotate the pushrod freely, at that point tighten the lash nut until you begin to feel drag on the pushrod when you rotate it. Then tighten one full turn. repeat for each valve. If it is a solid, then yes you set the lash (again with lifter at bottom center of the individual lobe) with a feeler guage according to cam specs.

---

Engine turning but car not starting..? 2002 Olds Alero?

Valve* SBC* Roller Rocker*

---

I get check engine sign when I turn on A/C in 2001 corolla?

no, they are hydrolic lifters.all you do is put the lifter on the low cam and torque the rocker bolt.

---

More Questions & Answers ...

How much would it be to put a dual exhaust on a truck?

Why would headlamps go out twice in 2 months?

Would anything happen if I spray paint the muffler tip?

Fuel octane ratings?

I can't seem to get my remote radio controls on the steering wheel to work on my Stratus.. any suggestions?

What can I use to get a stain out of my car seats?

How big a tire can I have installed?

I have a 1996 oldsmobile cutless surpreme it will just die starts right back up and as long as i am giving it?

Can I drive a vehicle with a cracked flywheel?

Is K & N filtters are really good for you car truck or SUV?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.