How can you tell if the big ends have gone on a golf gti?

Question:


Answers:

'90 Ford Ranger Transmission issues?

Ive had a big end go,and boy you would now if yours has gone.It sounds like really heavy knocking,from the centre of the engine,will be quieter under load and more noisy on the gas.Check your timing though,because if its to far advanced,that can cause a similar noise,but not as loud.

---

How much to repair a serpentine belt on my Lumina?

Heavy knocking rattle from deep down in the engine, varies with engine speed; if that's happening, have it seen to now, before the crank gets damaged. But ask the garage to listen first, to confirm your diagnosis.

---

4Runner Shakes-Shudders?

When u rev up the engine it will knock like hell low down in the cranck case, if it has just started it may just be the big end bearing shells, but continue to drive the car, you will wreck the crankshaft.

---

i have a 51 plate 106 , its only done 37,000 mile and the engine maintenace light has come on what shell i do?

If they dont answer the phone try going round and knocking on the door.

---

More Questions & Answers ...

i've a toro s-630 snowthrower and when i start it it tends to stall ,?

What is the best way to clean a car's motor?

where is the starter located on a 1995 lincoln towncar and how can i unlock it?

speed ohmmeter broke 2003 chevy does anyone know why??

How much mileage is too much mileage for a volvo? Do they have more problems (mechanically) like other cars?

Question about my car Only serious answers please?

what's wrong with my car....??

how 2 clean headlight lens?

how to take a hub cap off a mercury?

i am geting a new lawn mower?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.