My Toyota 92 4runner 3 litre is in the shop for a head gasket job.?

Question:
After looking at the short block, there is a small grove that took 3 or 4 trys to feel where the grove or pit was, should i just pay $1500, and fix the head gasket, and take my chances, or pay the $4500 and just put in a rebuilt motor?Engine now has 242000kms

Answers:

will 2005 intrepid r/t rotors fit a 97 intrepid?

I say the rebuild. 242000 miles is a lot of miles and I would hate for you to waste 1500.00 if it does have a cracked head.

front end alignment?

is a 92 send it to the junk yard its done

car trouble?

if the groove is not a crack near the cylinder bore,clean it out a bit with a rotory tool and fill the groove with jb weld smooth flat and put it back together

2006 Toyota Tacoma. How do you reset?

jb weld is not for this type of repair. hone the cyls and live with a very slight lose of compression if its not completely removed. a 92 is not worth the price of a motor. send the head to a shop to see if it is still ok, then make the decision. what is its value where you live because 4500$ is alot towards another vehicle

can this happen?

I wouldn't put that much into a 25 year old vehicle.

how do i remove 1995 modeo fuel pump desiel?

I don't know why You people always diagnosed to the worse all the time.

Confirm: coveralls for working don't come in 100% synthetic because they'll melt when exposed to heat or fire?


if is not broken ,don't fix it!!!

gearbox wanted?


Who said it was the head gasket?

my buick regal has a skip to the engine and i have clean injectors and a tune up. any help be great?


You are talking about a grove.

You don't say "overheat,shaking,stall,leakin...

How much should it cost to get the radiator flushed?

a valve job for 1500 is about right and will give new life you should be ok
More Questions & Answers ...

  • Engine Find In Southern California?
  • Where do I put the POWER STEERING FLUID for a 97' Pontiac Transport (minivan)?
  • how reliable is a transmission after you convert it from automatic to manual?
  • How do you fix torque converter shudder?
  • I am looking for a detailing job in Saint Louis, MO?
  • Help! Anyone know the location of spout connector on a 1997 Mazda 626 for timing??
  • Why do the 4WD Auto and Low lights flash on my Ford Explorer?
  • My car is not starting?
  • How much are you paying for regular gas in your area? Where are you located?
  • could it be my ecu computer?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.