My car was running hot - chemi-weld?

Question:
I check my water and oil every day and one day while driving (Mazda MX6 turbo) and was 5 mins from work my temp gauge was nearing hot and drove the rest of the way to work but later on when i went to leave and after topping up the water she was running really rough so i turned her off and had one of the guys at work have a look and a little hose had a split in it. he fixed it up and i started it and was running fine but got a tow truck just in case coz the radiator was bubbling and think that i might have blown the head gasket or maybe even stuffed the head? Should getting it reconditioned be the best? or can i chemi-weld it?
what do u think? btw im in Australia.

Answers:

I just bought a used blue bumper cover for my car, but I need to paint it red. What should I do before paintin

Have a repair shop run a diagnosis on the engine. There is a chemical that you mix with the coolant that will let you know if there is a blow in the head gasket. Does the vehicle have high mileage? If so I do not recommend head work. Machining the head will cause higher compression which will put more strain on the lower end (ie oil pump, rod bearings etc....) Lower end can go out. It's like throwing money away! If you do have higher mileage look into getting a lower mileage used engine.

how much should front brakes cost for a 2003 honda civic . I also need my rotors cut?

Well, first you have an overheating problem, if you have to add water everyday, that is a problem. Water either leaks outside the engine or indise, if your temp guage went high and your water level went low then your head gasket is bad and your engine is burning your coolant. If you auto just overhated breifly the head might be ok. Take it to a shop and have the head gasket replaced. They can check the head at that point for cracks and if it is warped.

Head gasket repair complications - liability?

instead of jumping to conclusions why don't you do a little investigative diagnostics.? ok ..the car over heated.so what!? it could be the thermostat stuck closed.....it could be that little hose your friend found that caused the overheat........it could be the radiator cap being bad that caused it to overheat.....what about the water pump?! there are alot of things to check out befor you go condemming the head and throw away alot of money for nothing. have a block check done . It tests for exhaust gasses in the cooling system.that will tell you if it is a head or headgasket problem right off. do a pressure test...that tells also....
More Questions & Answers ...

  • 99 Jeep Cherokee with low oil pressure @ idle?
  • Anyone have any idea how much it would cost to replace a 98 ford taurus motor, labor included?
  • my car alarm remote light stays on eventhough it works fine, but the LED stays on on one remote control. Why?
  • Their are 2 baseboards wired to one thermostat. The heat will not shut off when the desired temp is reached.?
  • Where can you get a engine for a geo tracker?
  • Lowering a 96 4 door Explorer?
  • I Need a new Hood for my car and a front grill. How much does that cost probably?
  • my 1996 chevy lumina runs like it,s going to stall but it doesn,t and the engine light is on?
  • If Computer can't pick up what wrong a car? Nothing comes up? What could it be?
  • Transmission leaking where housings meet on Dodge Ram 1500, what's involved in the fix?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.