Question:
Once my 50000 mile free maintenance is up, I am not inclined to be doing an oil change at a BMW dealership (it is very expensive). My neighborhood mechanic is willing to do it, but he doesn't know how to reset the oil change reminder gauge. The 5 bar gauge that gradually disappears until 15,000 mile is up and reminds you your next oil change is due. Anybody know how to reset that after oil change?
Answers:
how much would it cost to get a body kit installed and painted on a 92 eclipse?
http://www.autoshoppingcenter.com/servic...what can happen if 2 of the motor mounts really go on a car??
Your dealer might tell you if you ask.i am looking to buy a truck but i don't want to pay to much a k w or f l or pb?
See if your local auto shop has All Data or a repair program and it well tell you how to do it.
what equipment will I need to manufacture brake pads and friction products?
I will check tomorrow if possible.
how are 2 stroke engines cooled?
1. Key in 0 or off position.I have SKODA FAVORITE car model 1994, i have just purchased it?
2. Press and hold odometer button and turn key to 1 or acc. position.
3. Keep button pressed until any of the following words appear in display: "oil service" or "inspection", with "reset" or "re". For vehicles with "high cluster", the fuel amount (in litres) remaining until next service is displayed (i.e. 3224).
How many tyres for a Truck................?
4. Press and hold button again until "reset" or "re" flash. If there is no "flash", minimum consumption value has not been met.
2001 Yukon the heat comes out at full heat & the temp control has no affect?
5. While display is flashing, press button briefly to reset service interval indicator. After display has shown new interval, the following will appear in display for approx. 2 seconds:"END SIA"
How do you fix torque converter shudder?
For model year 2000 or early production 2001's:
Resetting the service lights can be done by one of two ways, firstly specialist tools are available for around $95+ that plugs into the diagnostics port and reset the lights automatically, or you can do it manually using a paperclip or small length of wire. To do it you need to unscrew the dust cover from the diagnostics connector (attached the the suspension turret ) and turn the ignition switch to position two - this is where the accessories come on but the starter motor doesn't engage. Create a short between pins 7 and 19, hold this in position for 5 seconds for an oil service, or 10 seconds for an Inspection. See the picture below - looking at the orientation of the "pacman" helps.
Take off the piece of wire and turn off the ignition. When you turn the ignition back on you will see the service lights are all green bars.
One way to make a jumper is to use a 16 gauge wire, stripped on the ends, twisted and then folded over once to make it thicker. Just make sure you don't touch any of the other pins when one is already connected.
The light reset is done not just by time of "jump" of the pins but by breaking the circuit after the correct time. To reset Oil Service lights engage for approximately 5-6 seconds then release. For the Inspection lights, engage for approximately 10-12 seconds then release.
Mazda B2600I Lost #2 & #4 Injectors?
Good luck.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.