Question:
The car is a Renult Laguna 2.0 RXE the gearbox appears to select a gear but does not drive the wheels. I can put the car into gear without using the clutch with the engine running and the gear box appears to have been leaking oil. There were no sighns of the gearbox dieing befor hand no clutch slip or any thing i was driving it and lost drive to the wheels. When its in gear the MPH needle reeds witch would indicate drive from the engine to the gearbox. any ideas
Answers:
my stats r 32-25-36.cud u plz suggest the cut of salwar kamiz tht'l suit me.?
Think if you open up your gear box you will find a lot of little broken metal bits. On the other hand if you can select gears easily you might find the syncro is doing a good job and may be the differential that has gone AWOL. Sounds nasty.If i need a new rim because it is bent, does it do me any good to get the alignment done 1st?
Sounds like a job for the garage could be your selector or gearbox itself or diff hope you have a bit of savings. when garages charge from £30 to £60 per hour that's what my local vauxhall agent charges anyway. But good luck hope it's not seriousI'm not familiar with that particular car but I had a Plymouth do that.
The r/f axle came out of the trans-axle just enough to not engage with the splines.
The motor shifted to the left because of worn motor mounts.
The MPH works of the output of the deferential so that shows that gear box and clutch are working ok..
If the gear box was broken as suggested there would have been loud noises.
I think your problem is between the differential and wheel.
can i put a later model supercharged 3800 into my '96 regal coupe?
Somewhere there is a connection between the clutch and gearbox that is gone. Cheaper to buy seconhand box than get it repaired at garage.What would cause a truck to attempt to start without the key in the ignition?
I would check that both drive shafts are not turning when in gear and standing , if they are not moving either your clutch has collapsed or your gearbox is caput. If the shaft is turning and it is not moving then it has taken out the driven splines in one off the hubscommon problem,the splines on the o/s driveshaft,diff side are rounded away causing the no drive.
how to find the temperature cooling sensor on a 2003 f150?
c v joint goneMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.