Question:
the security light comes on and i dont know the problem?
Answers:
How often should I wax my car?
Your problem is either a bad BCM or Passlock sensor in the ignition switch. I have seen both problems. Check the BCM connector for corrosion at the plug. If no problem found i would replace the ignition lock cylinder and housing. You will need to do re-learn procedure in order for it to start.You might try the relearn next time it does not start and see how long it last. Sometimes the problem is very intermittent.
What is the cost for installing Keyless Entry System in a 4 door Car?
Programming Theft deterrent System. 30 Minute relearn procedure.
Turn on ignition, with engine off. Attempt to start engine, then release key to ON position. Observe the SECURITY light flashing, after approx 10 min it will stop. Turn OFF the ign. and wait for 5 sec. Repeat steps 1 thru 4 two more times for a total of 3 cycles or 30 min. Vehicle is now ready to relearn passlock data code on next ignition transition from OFF to Crank.
installingwaterpumpon97oldsmobile 88?
It might be a code in your car's computer. Make sure you have the keyfob to turn off the alarm. If you do, and you still have troubles, then you will need to take your vehicle to the dealership, and have them reset the security system in the car after testing it to make sure there is not another problem. Good lucksounds like maybe your security chip inside your key is starting to go bad. Take it to your local GM dealer and see what they say, but that sounds like your problem to me.
OK will a single t3 turbo be fine to run on a stock 350sbc accept for forged pistons?
Bad passlock sensor, Have the ignition cylinder replaced.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.