Question:
I am looking to find out how to install my Sunpro Tach. in my old Ford LTD. It has a 351W 5.8L engine. Where do all of the wires go and how exactly do I go about installation? What are the steps and procedures? Thanks for any help in advance!
Answers:
How much would it cost to replace a rack and pinion part on a car?
the black wire should be run up to an ENGINE ground; this could be to an intake bolt (often intakes have a post just for this) or a ground strap on the engine block. The red wire goes to the NEGATIVE post on the coil. If there's another wire, this is for the gauge light; run this to the fuse box and put it to one side of the fuse that runs the dash lights (and fog or parking lights). if there is another wire, it would be for the ground for the light cicuit; any chassis ground will work.Motor oil viscosity's? 10W40 , 20W50, straight 10 weight, 5Wtf?
have fun!
I just bought a feeler gauge, and it was all covered in oil...is this normal?
just makes me wonder if the tach is worth more than your ltd,what is it a 3 or 4 wire setup,the big red one plugs into your distributor the black wires are ground and he other red wire is for your lightHow do you test a fuel regulator?
should come with instructions but black is a ground wire,red goes to a the fuse panel like in the radion fuse,white is for the light and u also put that in the fuse panel and green goes to distribuator it might say tach on it and plug it inMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.