Manual trans. problem, having prblem getting it into gear?

Question:
93 mazda b3000 80,000 miles has had a prblem getting into gears fro a long time, when changing rears you would have to take it out of gear and wiggle back and forth to grt it to go to the next gear... now I can't get it in to the next gear at all...

Answers:

Is the "brakes" club better than the "steering wheel" club?

Well I know you've figured out that it the clutch, more than not or clutch assembly, the throwout bearing not doing it's job.

---

Can you put a rpm gauge from a manual tranny car into an automatic?

check the clutch master cyl. it is a hydrualic system, and probably has a leak in the master or slave cyl. if the master is low, fill it then bleed the system to check, if that helps, find and fix the leak.

---

Tail lights on 03 4Runner keep blowing immediately upon replacement. What's the problem?

I had a car with the same problem. Try double clutching - pumping the clutch twice before you put it into gear... but I think its time to go to the mechanick 'cause you're gonna do serious damage to your car if you continue to use it like this. Good luck!

---

Does the warranty includes the changing of the distrubition chain & all the plastic components in the engine ?

all the gears do this or one specific gear? If its just one gear u have problems with its probably a synchro gone. if its all gears you need a new clutch

---

What other parts are replaced along with the timing belt?

Push in your clutch. when that don't work, take it to your mechanic and ask to have your clutch looked at. If alls well go see your doctor, maybe your clutch knee is weak..doctors know all about that stuff.. lol Or look at your owners manual and find the 800 number, and call them...explain your problem.

---

Tyres should i change em.?

Clutch gone bad? Does it slip? Try revving the engine to the right RPM for the speed you're going in the gear you want, then see if it will fall into that gear...if yes, then clutch is bad.

---

More Questions & Answers ...

95 integra LS, shifting but no power to the wheels?

Please help with a 1990 Jeep Cherokee problem?

I will give 10 points to the person who answers this...?

I had my front and back brakes changed now they are VERY tight?

1995 gmc jimmy 4.3 vortec engine having a hard time starting. Fuel problem?

Apparently I need my car aligned. Would that cause a shaking/rattling noise in the front when I drive?

Driving in high gear saves you money or screws up your transmission?

My buddies got a 92 isuzu pickup that runs ruff?

Does a 5.0 jeep motor have a place for a dip stickl?

Where is the flasher for turn signals located on a 99 Pontiac Bonneville SE?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.