Skunk 2 Coil-Over's / 96 Civic Ex?

Question:
I want to install some Skunk2 adjustable coil-over's on my 96 honda civic ex........
I want to know if this will be a fairly easy installation
or will it be a pain in the rear.
Will there be any Welding involved, and can I keep the stock Shocks ?
I have 15 inch wheels on there now so I know the height of the wheels will not be a problem.
Most helpful answer will get the points but I do appreciate all good feedback.

Answers:

How many miles (approx) can you do on set on new quality brand car tyres ?

More than likely, you'll have to take it to a garage to have them take off your springs unless you have the tool to compress the springs. If you're buying coilovers than you won't use the stock shocks anymore, the coilovers replace the shocks and springs in one whole piece. If you are wanting to keep your stock shocks than you only need to buy lowering springs but then it won't be adjustable. No welding involved, the coilovers will be "direct replacement". Hope this helps.

---

More Questions & Answers ...

How Do I Change a Fuse on my 2004 Mazde RX-8?

how do you remove a grade 8 bolt if the threads are stripped and it wont come out of a chunk of steel?

Have you ever had a "heater core" go bad on you?

what lubricant oil should i use in nissan micra petrol in uk?

What is overdrive in an automatic transmission?

How dose one change a fog lamp bulb in a 2000 Pontiac Bonneville?

does anyone know were the clutch fluid reservoir is on a volkswagon sharan?

Knocking noise?

no battery light when i turn the ignition?

When I start my car it sounds like it is having a hard time reving up. Then about 10 seconds later its fine.?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.