How to get broken pipe fitting out?

Question:
I have a piece on my Denali that broke off in the hole and just the threaded part is left in the hole. The center is open like a pipe but the threads are left and I need them out so I can put the new piece in the hole

Answers:

So why are 4-cylinders labeled as "fuel economy" when they actually do worse in MPG than some 8-cylinders

Yes very common pot metal heater hose connector you can pound a large enough screw driver blade with square shaft into it and turn the screwdriver with a cresent wrench. Or use a hacksaw blade and cut into the remaining pot metal two places 180 degrees apart just to the threads then hammer and cold chisel the parts inward the pot metal will crack grab with needle nose pliers and work the two pieces out. Good luck happens every time the manifold or heater hoses are removed

---

Need help on a quad 4 engine?

You can very carefully get a drill bit about the same size as the hole. Drill into the center of the pipe and when it grips put your drill into reverse and it just might unscrew it.

---

A/c pollen filter replacement on 2005 Honda Civic?

Go buy an EZ-out and a left handed drill bit!

---

Has anyone ever had to replace the back glass in the Chrysler Sebring convertible? How much did it cost?

Sears has the right toll for this ,It is called an easy out... like a large drill bit but has reverse teeth and toy put it in a socket wrench and it will remove the piece

---

Do Tires feel different after tire rotations?

Depending on the pipe size, I have used a hack saw blade and cut the old pipe long ways in two places and then took a chisel or screw driver and knocked it out.

---

Are Twin Throttle Carbs less efficient than SU type Carbs?

denali , thats a car ?
what you might use . bolt extractor . it's taperd with edges that grip . harbor fright tools will have the best price .
or a tool store . hardware store ect .. .
i 've used chisles or chanle lock end , or other various things.

---

Truck making a whining sound?

Be careful If you use the hacksaw blade method, be careful not to damage the threads. If you use the chisel method, be careful not to damage the threads or break the heater. If you use an easy out, it is fairly safe but can still damage the threads so use just enough pressure to get a grip. If you use ANY method be VERY careful not to let the pieces drop into the heater. Sometimes things are more loose than you might imagine.

Tire/Wheel shaking?

Pops

---

When I make right turns and go over SOME bumps in my car I hear a slight knocking sound...What could this be?

You get an ez-out for that size hole.

---

More Questions & Answers ...

How do I wire foglamps?

Charging six- six volt in in golf cart?

What does it mean when #10 fuse keeps blowing in my 2001 plymouth neon?

Need DIY info on replacing my 03 Windstar SEL cabin filter.?

Can a digital odometer be rolled back to show less miles than actually driven?

What wood be best motor 305 or 350 or what?4 a 1978 cutlless calais and also a good price.?

1993 ponitac sunbird where is fuel pump located?and how do i access it?

Buick regal t-type?

What are the tail light laws in NY considering broken covers and fixing it with colored transparent tape.?

Why is my car rev'ing on its own?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.