My pug 306 LX is reving WAY to high.?

Question:
I had a proplem with it before xmas and it was the injector/idle control sensor causing it to rev up and down between 2000-3000 and stalling when the clutch is pressed, me and my dad fixed that and its been fine since, but when i went to start the car tonite as soon as i switched it on it went straight up to 8000 revs!

2007 Toyota Camry question?


Could anyone put a bit of light on the subject?

Gas milage problems?


I havent had chance to look at it properly yet but just wondered it anyone else had to same problem? and solution please!

Answers:

Car Problems: Can anyone advice please?

Hi

Workshop manual for VW Polo 2003 (UK)?


Your first check is to ensure the accelerator cable isn't sticking and the throttle is closed during idle.

What is water wheel?


Let me know how you get on.

Low warning light comes on my scenic?


Cheers

My car a 1993 ponitac sunbird runs well in very cold weather for about 15 20 min.then it seems to bog down.?


Geordie

My parents have tree sap on their car hood.?

It's a piece of French junk. There never has been and probably never will be a good French car. When will people realise that buying them is just a stupid waste of money. I had a Peugeot 407 as a hire car for 2 weeks last year. It was the worst car I have ever driven in 20 years. I would rather have the 10 year old Ford Cortina I had as a student back than drive one of them ever again!

Is it worth replacing a bent strut on my Oldsmobile?

Take off any valve like things located on the inlet side of the air system and give it a good clean out with some petrol or something,Might also have a sticky throttle position switch
More Questions & Answers ...

  • How can i get better gas millage from my suv?
  • Blue smoke part 2?
  • I need better instructions for the victor ehaust system repair kit V812 with screens. Instructions too vague?
  • 2002 Ford Focus - Electrical - PCM Board replaced. Other Electrical items haywire - Help!!?
  • What happens to Bondo if it gets wet, before being primered.?
  • What would cause an auto to not accelerate?
  • What is the best way to clean rust off of full 100 gallon propane tank and painting it?
  • Car won't start?
  • I hit a guys truck, while side swiped it and knock the mirror?
  • On engaging 3rd gear grinding noise occurs?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.