What can I do to adjust the striker on my car door panel?

Question:
The striker is the post that the door latch connects with. I don't know what tool to use to adjust this post. Thanks

Answers:

Do u think petrol should be cheaper.?

Generaly they need a #60 Torx bit.

Does anyone know how much it would cost roughly to get a moonroof installed in a car?

loosen it a little, and slide it where you want it, and tighten it back up.

---

How much does it cost to paint a C5 corvette? How do you remove the old paint?

A ratchet with a star socket.Usually a 22 mm.

---

I just replaced a bad starter in My 1988 Jeep, but now it just wont turn over. Loose connection?

usually you don't adjust the striker if the door isn't closing right, you adjust the door latch on the door itself.

---

More Questions & Answers ...

Need help with my 240SX?

1996 Dodge Dakota Check Engine?

How to pass the Nox2 Emissions Test?!?

My Legend is squeaking?

I want to ask if the car has alow hp and its have a 2000cc 6in line engine autotransm what will be the problem

What is the BMW's part number equivalent to 7852 601 174 061?

Honda Accord 2002 Gear Delay more than 3-4 sec?

What does it mean when the... O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)?

1998 expedition 4wd seems to sag in rear- anyone use air bags to stiffen the rear suspension?

I have a 1999 grand am when i try to start up my car the security light flashes and it will not let it start?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.