Isuzu Rodeo..why wont blinker work but flashers will?

Question:
left front and back blinkers wont work but you can hear the signal inside the car but it bleeps very fast...right side sounds and is normal. fuses and bulbs have been changed. flashers work all the way around.what could be causing this?

Answers:

Parking sensor?

There are two flasher control relays in most cars today, one for the Hazard" lights (your four-way flashers), the other for the Turn signals. Try replacing the one for the turn signals with the one for your four-ways, if this works, then you know the flasher relay is no good, and replace it.
They aren't usually expensive (a couple of dollars). If you tow trailers with your vehicle, consider getting the heavy duty flasher relay, as the extra lights on the trailer may burn out the standard flasher relay that was in the truck.

---

My car will not start! 240sx?

cuz it's not a good car. DUH!

---

How many quarts for a 97 mazda 626?

If you've replaced the turn signal flasher unit (separate from emergency flasher) and all the bulbs and it still doesn't work, then I'd suspect that voltage isn't getting to one of the bulbs. I'd replace the flasher and all three bulbs again.

---

How do I get rid of water stains/spots on my car windshield?

The fuse for the turn signals and the fuse for the hazards are separate, which accounts for the hazards working and the turn signals not. A short in the system will cause the faster than normal clicking you hear from the dashboard. I've seen this before when someone accidentally crushes a wire when re-installing a tail-light. Otherwise you'll have to put a circuit tester on the wires at the lights to see if they're seeing juice. (You can get a cheap probe-style one from a car parts place for like $6-$7) Hope this helps.

---

Please help my car is driving me mad?

it could be wires or something near the switch that you turn it on..maybe when you pull the stick upward (right) it works, but downward (left)...the wires may be fried or broken...hope this helps.

---

How could you prevent the leather interior & the dash board from cracking/chipping or deteriorating due to the

go to the fuse block near the brake pedal. locate the turn sig. flasher. usually silver the size of a quarter and an inch tall find another in that same area this should the flasher relay try switching them if this fixes it you have solved the problem.

---

More Questions & Answers ...

Need help finding the fuel pump oil pressure switch ? 99 s10?

ABS light coming on ,car wont start?

Automotive technicians, what is an A, B, C tech?

Help needed lady driver?

Is it possible and recommended for me to change brake pads in my car?

What engine combination for a chevy 350 would result in 450 hp?

No spark on my 87 Ford F-150, 5L engine.?

Question about front end alignment on a Chevy Express Van?

How much in uk pounds would a full respray for my honda accord be?

Help! My phone won't turn on or charge!?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.