Question:
So far I have replaced the water pump, belts, and thermosat. Plenty of fluid and it is flowing. The controls only work in certain positions. Like full fan and defrost only. Sometimes the fan just quits and then starts up again. Any ideas? Thanks
Answers:
Is there a smart way to stop bottom of my Lamborghini scraping on the speed bumps in the road?
Check you heater valve which is in-line with your heater hoses, this valve is controled by a small vacuum line, make sure the valve isnt frozen and the vacuum line isnt broken of off the valve.rust! what is the best way to free a seized part .steel and castalloy , semi sealed part ?
ya take it to the dealer & they cna help u outi would take it to a mechanic
just hold on to your balls and get heat from there
1990 toyota pickup fuel pump relay?
mechanic... cause ifhave no idea.Heater Core ??Expensive I think?Sorry Good Luck
Bad blower motor ground?
Fauly relay?
Faulty switch?
Faulty fuse? (loose)
Faulty power wire?
I have to fight to get my car into 1st gear. Help!?
It's kind of hard to test it from over here.
which cylinder is the number 6 on a ford 4.6?
This is a common problem with the jeep heating system and usually is a faulty heater baffle control. this is located under the dash in about the center. Is a bit difficult to find but easy to fix.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.