Its not a medalflake paint job,black factory paint on new truck and?

Question:
there are tiny flecks of what appears to be chips imbedded in the clear coat. dealer says that the clear would be taken down so far that there would be swirls and thats the final stage and condition that it would be in.it feels like they dont want to do it right and repaint.what do you think?

Answers:

i have had a tracker put on my work van is there any way i can use it nad not get cought?

Contact the manufacturer. In your manual, usually at the back, you'll find a toll free number for customer service.

---

everything in my car works, but it wont start. what is worng?

there shouldnt be any swirls in a factory paint job. the clear should have been smooth as glass. if you had this done at a shop then they didnt sand the clear or didnt sand it with the proper grit

---

How do I remove water/moisture from a gas tank?

Sounds like some crap to me. A new truck should have PERFECT paint. If not, then they need to remedy that. Do not take no for an answer.

---

user manual for chevy cavalier 2002 model?

I think you got a bad paint job from the factory -- or possibly a vehicle that was damaged in shipment and poorly repaired. The guy with the "quilt" paint job almost certainly had a damaged shipper. The dealer needs to put that right -- paint on a new vehicle should be virtually perfect. Some very slight "orange peel" effect is common on all but the most expensive cars but it should be nearly undetectable.

---

i have a 93 cadillac deville the temperature is displaying 74deg. but when i turn my car off it seems hot?

sounds like rail dust to me. when a vehicle is shipped via rail, the friction of the wheels on the track creates tiny particles of "hot dust" these particles melt into the clear coat causing a flawed finish. this can be corrected by wet sanding the entire vehicle with 1500 grit sand paper, then buffing the vehicle. then the vehicle is buffed with a swirl remover. this is not as easy as it may seem (leaving no swirls) a job like this could take several days, but it is done all the time. this should be covered under warranty if you recently purchased the vehicle! MY SOURCE... I WAS A NEW CAR MANAGER FOR YEARS/ CURRENTLY I AM SELF EMPLOYED GOING TO DEALERSHIPS REPAIRING FACTORY PAINT JOBS AS WELL AS REPAIRING CHIPS AND SCRATCHES ON USED CARS!

---

More Questions & Answers ...

my engine light comes on priodically for ford explorer 1996?

BMW 320D E46 Hazard Lights flashing ?

.cant figure out why i have no spark on my 1993 buick regal?

Why are my breaks squealling?

My dead car battery leaked fluid into the trunk of my car. Now it smells horrible. How do I clean it?

where should i go to learn about car engines, and building engines and whats good and not? and nos?

Macco advertises a $200 paint job, but........?

Car tires from 185/65R14 to185/70R14 does it affect too much?

how much does it cost to repair a clutch on a 97 ford ranger XLT?

How do you fix a warped mustang hood?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.