I have a 91 Polaris 350 ATV where the electric start is not working.?
There was only a clicking and was told that it was the selenoid. I replace it but there is now no power. Is there a fuse or something that I need to replace?
Answers:
-When you turn on the key, can you turn on the lights? Then the fuses are OK.
-The two thick wires on the solenoid, with a large screw driver, touch those two wires at the same time. If the engine cranks, then the engine, starter motor and battery are OK.
-Is the solenoid plugged in? A common mistake after changing parts.
- If the solenoid has a two wire plug - With everthing connected (battery & starter motor cables and solenoid connector), turn on the key and jump the two wires in the connector together. If the motor cranks, then the solenoid is OK.
- The only problems left would be a short in the wire harness, unplugged starter switch or bad starter button.
whats the color diagram for a moto plat mini six magnito maco 490 dirt bike?
Assuming you have bench tested your starter .check all of your connections make sure your ground connections are all good as well as your hot side .and check your fuses pull each one and with a continuity tester check to see if they are good (lights up :good /no light :bad ).check battery to make sure all of the cells are good .ONE BAD CELL YOU WONT HAVE ENOUGH JUICE TO DO ANYTHING (HYDROMETER TEST EACH CELL)More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2009 CarQnA.com All Rights Reserved.