Tighten loose front wheel steering on moped?

Question:
i recently bought a peugeot metal-x moped and found the front wheel to be a bit loose i was wondering if anybody could give me a rough guide as to how to tighten it. the wheel slightly turns bout an inch or so away from the handle bars i don think its a big job i just need to no wat i need to tighten it thanx

Answers:

I have a MINI QUAD AND THE CARBURETOR IS LEAKING GAS THROUGH THE AIR FILTER AS FAST AS WE CAN PUT IT IN THE TA

if its the wheel its self, then remove split pin on spindle then tighten the nut if nut is tight & you can not see any gap between the hub &forks check berings by uting bike on stand then with one hand hold top of wheel & the other bottom of wheel now push withone hand &pull with other & vice versa if wheel wobbles you have faulty wheel berings

---

tightening a chain on an Aprillias mx 125?

Frist i would remobe the axle and bearing clean them up, and instect for damage. If tyhey are o.k. pack with wheel bearing grease and re-install. Tighten down untill the wheel begind to drag, back off untill cotter key hole will line up , with wheel spinning freely.

---

More Questions & Answers ...

Where is a good place to by a Yamaha 660 Auto 4x4 for cheaper than the M.S.R.P?

What do I do with the hydraulic line on a 06 Sportster when I raise the handlebar height?

Price for a 1985 Honda CR500 dirt bike?

Whats a good brand of motorcycle helmet that has cool graphics, safe, and is full face?

cdi units on the cb250 and cb400 superdfeam?

When you get on your bike and take off do you know where you are going or just see where you end up?

For how many miles do most sports bikes run?

What is fastest production motorcycle built today?

how can i get?

can you use jb weld to repair a hole in a piston?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.