Question:
But once i put the gas in and fire it it only stays started for a few min then she quits what could it be
Answers:
What is the statistics on motorcycle accidents compare to other motor vehicles?
You either do not have enough gas in the tank or you have debree blocking the fuel from leaving the tank or entering the carb.Could it be a plugged fuel filter ? After it quits running do you still have spark at the plug? If not it is an electrical problem.Production Number's And Current Value On A Mint Condition 1979 Honda CM400A Hondamatic Motorcycle?
Honestly, it could be anything!Take the air filter off and clean or renew.
Check the HT lead for wear, and renew.
Check the coil for a good spark.
Check the fuel filter, and clean.
Check the carb float height, and float action, and adjust.
Check the choke is working smoothly.
Baja SC50 Scooter from Pep Boys . . . Any Good ?
sounds like its either the fuel pump or the map sensorDoes anyone else this phrase should be classed as a violation?
As Don E suggested, first thing you have to do is make sure gas is getting to the carb. IF gas is getting to the carb, then you still have a carb problem. You said you cleaned it, I hope that doesn't mean you just brushed the dirt off the outside. Pull the jets, ALL of them, hold them to the light, you have to be able to see light through them or it will not work. The hole in the pilot jet is very small if you can't easily unplug it just replace it. Make sure the float/needle/seat is assembled correctly, I have seen people try to put the floats in upside down. When everythings right its got to run.Where can I find owner's manual and tool kit for '02 Honda Reflex?
hi i have a 81 it 250 and 175.do you have compression?how long since you fitted new rings? also the crank seals may be leaking and allowing compression to leak. also decarbonise the exhuast it will helpWhat year did the 12bhp legislation come in for 125 motorbikes?
"greg e" gave the best answer. Most likely the top end (piston & rings, cylinder) needs to be rebuilt. If you don't have a compression tester ---Remove the exhaust pipe.
--Look in the exhaust port with a flash light and mirror.
--If you see any discoloration below the rings and/or scoring of the piston and/or cylinder wall -rebuild the engine.
--The worn out top end isn't creating enough vacuum to suck in fuel from the carb. That's why it runs when you put gas in the spark plug hole.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.