Help and diagrams on how to fit cam chain tentioner to 96 fireblade?

Question:


Answers:

Best product to seal a new leather motorcycle seat?

I changed out the auto tensioner for a manual one on my F4i before I sold the bike... this page has very good directions on putting the CCT in. Not sure how different the job would be on your fireblade.

Does a 113ci ultima motorcycle engine fit in a 1980 harley davidson lowrider frame?

http://www.bayarearidersforum.com/forums...

Where can I find a 6volt ignition coil for a 1980 hond c70 passport?

It is a very straightforward job when you are looking at it, but the ridiculously tight access makes it very time consuming! I almost think it would have been easier to pull the throttle bodies and airbox to get better access to the CCT.

My 01PW 80 runs well but?

Anyway if you are installing an auto CCT, follow the directions in the service manual to install. You need to retract the bolt before you put the auto CCT back in!

I have a 1981 Yamaha Virago with no title, what are my options as far as registering it (Legal or Otherwise)?

For a manual CCT, tighten the adjustment bolt by hand until you start feeling resistance, back out a turn or two, and turn the engine on. You should hear the cam chain rattling... you will know the sound when you hear it. If you don't hear anything the bolt is probably too tight, loosen the bolt until you hear the noise. Once you hear the cam chain noise, keep tightenting the bolt until it goes away, and then back out about a quarter turn. While holding the bolt with your hand, rev the engine over the entire RPM range to make sure there is no chain noise. Then tighten down the locknut and put some threadlocker on it. Ask the people on cbrforum.com if you run into any problems!

---

Motorcycle mechanical advice please?

How about buying a Haynes or Clymer Manual?

---

Motorcycle buying question?

--Remove the bolt at the end of the tensioner.
--Remove the old tensioner.
--Clean the gasket surfaces.
--In the end of the tensioner where you removed the bolt, there's a slot for a screw driver.
--Turn it to wind up the tensioner, then hold the screw driver from turning.
--Bolt the tensioner to the motor with a new gasket.
--Remove the screw driver.
--Install the end bolt.
--Turn the motor by hand to make sure the cam chain didn't jump.
--If you feel any resistance, a valve might be hitting the piston and the cam timing will have to be re-adjusted.
http://www.bikebandit.com/partsbandit/oe...
http://www.motocom.com/motorcycles/...

---

More Questions & Answers ...

What's your favorite color for a superbike?

Whats the smallest pocket bike in the world?

Where can I rent a sports quad?

Suzuki gs 500e?

Motorcycle tires?

KTM 85 SX and the AMA?

I got my suzuki 250 up to 130km but the dial goes up to 160. why wont she go any faster? really i tried?

Motorbikes and speed camera's?

Why when testing a 12 volt car\ motorcycle battery?

Isthere anywhere i can get an aftermarket airbox 4 an 06 yamaha blaster?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.