Question:
Could anyone help me discover where I can find the CC's for this bike? I have looked under the seat, on the motor, the frame, had the VIN traced through a yamaha dealer (who didn't have a clue..too old)
The only place I haven't looked is under the gas tank. I know the bike isn't any bigger than a 200 CC, and I know most of the Midnight Special's were 900 CC's. This was a limited edition bike, not an enduro type bike. So any help would be appreciated!
Answers:
If the VIN numbers are illegible and there is no title what do I do to see if it is stolen?
The engine size is cast on the Cylinder of the engine,,at the very bottom,usually on l/h side.Generator regulator with integral charging monitor that bolts on generator of 1978 sportster?
Cylinder is the Finned part of the engine,,with the exhaust pipe sticking out the front
(I apologize if You already know that,,,just making sure you know where to look :)
I'm thinking of making my motorcycle obnoxiously loud, do you think i'm cool if i do that?
May be hard to see because engine is black.
What can you tell me about a 1990 kawasaki concorse?
The numbers are also actual engine displacement,,,,
meaning a 350 Yamaha for example will be written as "325cc"
a 125 may be 123cc,,
a 100 might be 98cc,,,,and so on.
How many cylinder is yamaha virago535?
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>...
Here's the little Special
http://stlouis.craigslist.org/mcy/276567...
Trafic for renew the lisens for cars at giza?
Here's a illustrated Parts List with some service specs
for that bike
Anyone have a pre 2005 Willie G. Harley Davidson Jacket?
http://www.cmsnl.com/yamaha-rx50k-50-spe...
Squeeking wheel on my bike xj600n?
http://www.cmsnl.com/yamaha-rx50l-50-spe...
Where are yamaha motorcycles made at?
>>>>>>>>>>>>>>>>>>>>>>
Here's a picture of a typical engine cylinder and the location of it's engine size stamp
How do I adjust a motorcycle brake and clutch handle?
http://images.andale.com/f2/126/119/2524...
Motorcycle Frame and Engine Numbers?
You can see "535CC" clearly on the R/H one.
Those happen to be Snowmobile parts,,,,
but that's representative of most common/typical format.
Both those Cyls are facing Left=Front
I am looking for any triumph photos or history of the factory?
.......
Here's a variation,,,,
This one is facing Right=Front.
The Markings on r/h side of engine,,,on intake manifold at Rear of engine.
This was NOT common layout in that era.
Kawasaki 400 starter work on a Kawasaki 440?
Click the pic with yellow Mark,,,you can see a closeup.
It's written as "246cm 3" , cm3= CC,,,aka Cubic Centimeters
Hi, I want to get sat nav for on motorbike. any suggestions (easier the better)?
http://cgi.ebay.com/ebaymotors/1981-yama...
.........
Those examples should help give you an idea of Where to look,,,and What to look for.
Kinroad motorcycle, tyre pressures?
The number are Usually pretty good sized and fairly prominent.
Can you take a Vespa on the freeway?
With a black engine,,,it gets sorta camoflauged in the shadows.
So make sure you have Good Light when looking.
This question is for the Harley heades, is the 03' ultra standard frame the same as the 07 frames?
Hope that helps
650 twin or 1100 four
They made quite a few Midnight Specials over the years. From the XS1100 version to the 650 twin. Could yours be their lil brother the 50 c.c. Midnight Special? It was a tiny cruiser mostly black and gold single cylinder. I think it may have run a similar motor to the Pw50 but not sure. Hope this helps and I'd search the web and check for old sales flyers or old issues of Cycle, Motorcyclist, etc.. Good Luck.
The simple answer - contact Yamaha direct. They made the bike. They'll know which model it is. Your answer is just a phone call away.
http://yamaha-motor.com/sport/contactus/...
look at the bottom of one of the cylinders. should be cast into the aluminum.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.