Question:
Answers:
how to adjust a carburetor on a dirtbike?
most likely 2 things will happen your bike will run fine, and you won't have any idiot lights. i would recommend that you make extensions, just get some of the same thickness wire and some heat shrink butt connectors, connect extra lengths of wire all the same length preferably and then carefully heat each connector to shrink it and make water proof if done correctly there should be a little bit of liquid goo squzz out when it shrinks.as it cools it will harden the rubber consistency.will i need to rejet my hyosung gt650r as im fitting a viper racing can of a gsxr600?
Rather than cut them,go into the headlight and disconnect them from the terminal blocks. You can pick up the push pin removal tools at Radio Shack or a similar store for about $5.00. If you cut then you need to solder or splice. I'm assuming we are talking an American motorcycle. The bike will run w/o idiot lights.i would like to have diesel bike or bullet ........ur ideas pls ???
Worst case is that the bike won't run because it is a safety interlock for protecting the engine from low oil pressure, overheating, etc. You may need to twist the wires together and solder them. Robertwhere do i go to sign up for the occ chopper?
If you cut the wires the idiot holding onto the handlebars won't know if the high beams are on or if you have a lubrication system failure.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.